Section Parameter Setting
WLAN Settings Enable
Enabled
WLAN Settings Operating Mode
Infrastructure
WLAN Settings SSID Set the same SSID like for the WLAN AP (TCP Server)
WLAN Settings Authentication Type According to the settings of the WLAN AP (TCP Server)
WLAN Settings Authentication Key According to the settings of the WLAN AP (TCP Server)
IP Settings DHCP Mode
Client
IP Settings Host name Enter a name for the device within the WLAN.
Bluetooth
Table 42. CAN – CAN Bridge P2P WLAN Access Point mode, TCP Client, Tab Bluetooth
Section Paramete
r
Setting
Device Configuration Enable
Disabled
Wireless Peers
Table 43. CAN – CAN Bridge P2P WLAN Access Point mode, TCP Client, Tab Wireless Peers
Section Parame
ter
Setting
Servers - Leave the server settings empty.
Clients TCP
Enabled
Client
Configuration
Type
TCP
Client
Configuration
Enable
Enabled
Client
Configuration
Address Static IP address of the device which is to be used as Access Point.
Fix IP address of DHCP server (192.168.0.34).
Client
Configuration
Port
30000
CANlink wireless 4000 Device Manual
To Next Page
