ASIC Interface 5
If the monitoring time expires, the VPC3+C goes to BAUD_CONTROL state
again and generates the WD_DP_CONTROL_Timeout interrupt. In
addition, the DP State Machine is reset, that is, it generates the reset states
of the buffer management. This operation mode is recommended for the
most applications.
If another DP-Master takes over the VPC3+C, the Watchdog State Machine
either branches to BAUD_CONTROL (WD_On = 0) or to DP_CONTROL
(WD_On = 1).
VPC3+C User Manual
Revision 1.03 33
Copyright © profichip GmbH 2004-2006
To Next Page
Loading...