3.7 Repeat steps 3.4 through 3.6 to enter the set point times and temperatures for
the DAY, EVE, and NIGHT set points in the group or individual day while in
heat mode.
3.8 If necessary, repeat steps 3.4 through 3.7 to program the other groups or
individual days.
3.9 Once this is complete, place the “System” switch to “Cool”. Follow steps 3.2
through 3.8 to program the set point times and temperatures for the program
group(s) or individual days while in Cool mode.
3.10 After programming is complete, press the “Return” key or wait 15 seconds
for the unit to return to the normal mode.
To Next Page
Loading...