VIBTOOL 02.2009
14
Operation
While charging VIBTOOL, switch it off to keep the charging
time as short as possible.
VIBTOOL behavior during charging
1. VIBTOOL power is off – Power supply unit is plugged in:
If VIBTOOL is not fully discharged, the device switches
on and the messages ‘Char’ (= Charge) + ‘Strt’ (=Start)
appear consecutively on the display.
VIBTOOL then switches off while battery charging con-
tinues.
If the battery is fully discharged, the device switches on
and off repeatedly until it continues charging while it is
switched on (see also Point 2).
If VIBTOOL is left inactive, it switches off automatically
after 10 minutes.
2. VIBTOOL power is off – Power supply unit is removed:
VIBTOOL switches on. The message ‘Char’ - ‘Stop’
appears on the display for 7 seconds. Also, ‘Lo’ or the
battery charging level in percent appears before VIB-
TOOL switches back off.
3. If VIBTOOL is switched on while it is being charged:
VIBTOOL is ready for operation and the ‘Batt.’ symbol
lights up steadily to indicate charging.
4. If VIBTOOL is switched off while it is being charged:
The display switches off and charging continues.
5. VIBTOOL power is on – Charging stops (power supply
unit is removed or battery is full):
VIBTOOL remains ready for operation and the ‘Batt.’
symbol goes out.
6. VIBTOOL power is off – Charging is completed:
VIBTOOL switches back on and the messages ‘full’ +
‘charge’ appear consecutively on the display.
Press the M key to switch to operating mode, or switch
VIBTOOL back off: Unplug the charger from the mains
or press the UP/DOWN keys simultaneously.
If VIBTOOL is left inactive, it switches off automatically
after 10 minutes.
To Next Page
Loading...
