VIBTOOL 02.2009
4
Introduction
Introduction
VIBTOOL is a robust hand-held measurement instrument
with built-in sensors for vibration, RPM and temperature.
These sensors can be used to measure the following 5
parameters:
Vibration acceleration
Vibration velocity
Bearing condition (Shock Pulse Method)
Cavitation
Temperature
RPM
Two operating modes are available:
1. ‘Bluetooth’:
VIBTOOL obtains the measurement parameters from an
associated PDA computer via a wireless Bluetooth con-
nection. The measurement results are transferred to the
PDA computer and, from there, evaluated and saved
using special software.
2. ‘Preset measurements’
VIBTOOL contains measurement tasks with preset pa-
rameters. The measurement results can only be dis-
played. It is not possible to store the data on or to
transfer them to a PDA.
External vibration or temperature probes can be plugged in
to measure at locations that are difficult to reach.
VIBTOOL's primary function is as a 'multimeter' for general
on-the-spot measurements. Engineers can walk around the
machine hall with VIBTOOL and take immediate measure-
ments of machine conditions. Try it out...
Bluetooth
PDA
To Next Page
Loading...
