VIBTOOL 02.2009
5
Safety notes
The VIBTOOL housing may only be opened by authorized
technical personnel.
Operation and maintenance are to be performed only by
properly trained personnel.
Repairs to the VIBTOOL instrument may be carried out
only by a PRÜFTECHNIK-authorized service technician.
Only original spare parts and accessories may be used.
Only properly functioning, regularly-maintained electrical
equipment may be used. Any defects such as broken plugs
or loose sockets must be corrected immediately. Damaged
cables must be replaced by an authorized service techni-
cian.
Any alterations that affect instrument design or operating
safety require explicit prior approval of PRÜFTECHNIK AG.
The relevant safety regulations must be observed during
measurements on machines.
Authorized use
- VIBTOOL may only be used to record machine vibration
signals, rotational speed and temperature values as well
as condition parameters of roller bearings in industrial
environments.
- For measurements with external transducers and for
data transmission via serial interface, only use the
connecting cable provided for this. Transducers and
cables may only be used for their respective intended
tasks as described in the corresponding product summa-
ries.
Any other use constitutes improper use and is prohibited.
PRÜFTECHNIK AG assumes no liability for damage result-
ing from improper use.
Moreover, the European installation instructions EN
60079-10:2003ff must be followed.
Attention!
Introduction
To Next Page
Loading...
