EasyManua.ls Logo

Ptotec 3300 - 30.0 Appendix 1. Accessories Available for the 3300

Default Icon
44 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
93-530-70 Issue 0 Page 40 of 44 © Protec Fire Detection PLC 2007
30.0 Appendix 1. Accessories Available for the 3300.
The following accessories are available for the 3300 control panel.
1. S3000 Optical Smoke Detector (3000/OP)
A high performance optical smoke detector.
2. S3000 Optical Heat Detector (3000/OPHT)
A high performance thermally enhanced optical smoke detector, designed to give higher
immunity against false alarms.
3. S3000 Heat Detectors (3000/TEMP56, TEMP64 and TEMP84)
Three high performance heat detectors.
The TEMP56 provides anticipatory (rate of rise) action with a final set-point of
56 degrees C.
The TEMP64 is a fixed set-point unit, with a trip level of 64 degrees C.
The TEMP84 is a high temperature device with a fixed trip level of 84 degrees C.
4. S3000 Base (3000/BASE)
A base with in-built low Voltage drop diode for use with all the detector products mentioned
above.
5. 3300 Manual call point (3100/BGK)
A Manual Call Point Unit with built in 180 resistor.
6. S3000 Sounder Base (3000/SB)
A high output 24V powered sounder base that accepts a detector.
7. S3000 System Sounder (3000/SSR2)
A high output, low current, 24V powered system sounder.
8. S3000 System Sounder Beacon (3000/SSR2/LED/R)
A high output, low current, 24V powered system sounder with integral LED beacon array.
9. 3300 4 Wire Repeat Panel (3300/RP)
This unit is designed to be connected to the 3300 external expansion port, up to eight repeat
panels may be connected. Each repeat panel must be configured with its own node number
by a DIL switch on the PCB.
10. 3300 Fire Link Interface (3300/FL)
This unit is designed to be connected to the 3300 internal expansion port. One fire link PCB
may be fitted into a 3300 control panel. The 3300 Fire Link Interface gives a monitored output
to a fire station call unit. The interface must be allocated a unique node number on the 3300
expansion system, using the on board DIL switch on the fire link PCB.
The 3300 fire link interface must be used in conjunction with a 3300 Fire Link End Of Line unit
(3100/FLEOL)
www.acornfiresecurity.com
www.acornfiresecurity.com

Table of Contents