Ptotec 3300 - 5.0 Installation Procedure; Unpacking and Component Removal

93-530-70 Issue 0 Page 8 of 44 © Protec Fire Detection PLC 2007
5.0 Installation Procedure
The 3300 fire alarm panel circuit boards are housed in a plastic enclosure. When the front is removed
from the panel the circuit boards and the batteries are fully accessible. The panel can still be
controlled even though the front has been removed.
The panel can be surface or flush mounted.
The panel must be located internally in an area that is not subject to dampness, extremes of
temperature or physical abuse. The environmental limits are given in section 21.0
1) Unpacking
After opening the box remove the installation template and spares pack from the packaging,
leaving the 3300 in the cardboard box for protection.
2) Preparing the Mounting Position
Use the installation template in conjunction with a spirit level to mark out the fixing locations
for the panel. Drill and plug the mounting holes previously marked.
3) Removal of the Door
Remove the 3300 unit from the packaging. Remove the two screw covers from the lower two
corners of the front door and unscrew the two front door fixing screws.
Swing the door upward from the bottom and lift away, see figure 5.0.
Put all removed parts in a safe, dry place.
Figure 5.0 – Removing the door from a 3300.
www.acornfiresecurity.com
www.acornfiresecurity.com