9
6 Unpacking, Mounting and Installation
6.1 Unpacking
Inspect the shipping carton for obvious external damage. Note on the carrier's bill-of-lading the
extent of the damage, if any, and notify the carrier. Save the shipping carton until your
controller is started up.
If shipping damage has occurred, call the Pulsafeeder Customer Service Department at
(800) 333-6677 and return the controller to the factory in the original carton.
6.2 Mounting
The controller is supplied with four mounting feet and can be mounted to a panel or to a flat non-
vibrating wall.
Attach the four mounting feet to the back of the controller enclosure.
Install on smooth surface to prevent stress on the mounting feet.
Do not install on vibrating wall.
If enclosure is installed in corrosive environments, consider purging.
Dimensions indicated as inches (millimeters).
The enclosure material is PVC.
Use #10 mounting screws (4).
Avoid drilling or punching additional holes in the controller enclosure. Damage incurred
as a result of any alteration to the enclosure is not covered under the Pulsafeeder product
warranty.
The dimensions of the enclosure in inches are:
To Next Page
Loading...
Need help?
General
