Pulsar PS-1HCE - Installation Equipment and Tools; Pre-Installation Checklist

To Next Page

To Previous Page

Pulsar® Precision Operaon and Installaon Manual (Model PS-1HCE) Rev 2.0 04/2022

4.2.2 EssenalEquipmentSuppliedbyOthers

 1 ½" Sch 40 pipe

 Two (2) 1 ½" ball valves

 1 ½" Sch 40 elbows, 45° and 90°

 1/2" [1.27 cm] exible tubing

 PVC primer and glue

 Saddle clamps for connecon to 1 ½" PVC pipe from pool return (oponal)

 Plumber's tape

4.2.3 COTSTools

 Drill

 1 ¾" hole saw and 1 ½" NPT tap (oponal)

 11/16" drill bit and 1/2" NPT tap

 Saddle clamps (oponal)

 Pipe wrenches or gas pliers

 Tubing cuers

 Saw (to cut PVC pipe)

4.2.4 PPE

 Safety glasses

 Rubber gloves

 Apron

4.3 Pre-InstallaonChecklist

Table1. Pre-installaonChecklist

ItemNo Check Completed?

1 Is a licensed electrician available to perform necessary electrical wiring of the booster pump?

2 Does the site meet all criteria noted in Secon 4.1.1, Site Requirements on page 9?

3 Have inlet and outlet locaons on the pool return post lter been idened?

4 Are all Pulsar® Precision components on hand?

5 Is all essenal equipment supplied by others on hand?

6 Are all COTS tools and other equipment on hand?

7 Is all PPE on hand?