Pylontech PowerCube-H1-V2 - Page 32

The ADD address shall set follow table
The ADD of each control module must be set different, setting it to the same will indicate a fault. The address
range must be set to 1-7, other addresses will not be recognized.
Table of the control module ADD address setting for Multi-strings
CAN Address
Slave7
Slave6
Slave5
Slave4
Slave3
Slave2
Master1
Invalid
Address dial bit
6(Terminal Resistance)
0
Master or slave
relationship
The terminal resistance
needs to be activated ON
(upward) at the
first(master control) and
last node(the last slave
control), when multiple
controllers are connected
in parallel.
54321
ON
6 6
OFF
1 2 3 4 5
6
Note
When both V1 and V2 versions of the control module are present in the BESS, the V2 version of the control
module must be the master.
1
2
3
4
5
6
1 2 3 4 5
6
1
2
3
4
5
6
1 2 3 4 5
6
1 2 3 4 5
6
1 2 3 4 5
6
28
/
42