EURO 46, 162 & 280 Programming Manual
Page: 39
Appendix A. Defaults
Engineer Menu’s
Clean Start 2000
(Grade 3)
Clean Start 2002
(Grade 2)
INHIBIT FIRE / HU? No [0]
SOFTWARE REVISION
CHOOSE MODE
Detection Mode* EOL [1]
EOL Range 4k7/2k2 [1]
EOL Mode DR [1]
Input Response 300ms
Input XDF* Normal [2]
INSTALL ZEMs
ZEM Address No [0] (for all ZEM addresses)
WIRELESS DEVICE CONTROL
Control Inputs
Control Bells
Program Keyfob Buttons
Lock [1] Set Area [2]: Area A
Unlock [2] Unset Area [3]
I [3] Set Area [2]: Area B
II [4] Show Status [1]
Lock + Unlock [5] No Action [0]
I + II [6] Hold up [6]
Lock + I [7] No Action [0]
Unlock + II [8] No Action [0]
CHANGE INPUTS
Inputs All inputs unused
Input Area A (if input programmed)
Input Areas Any [0]
Input Attributes
Chime No [0]
Omittable No [0]
Double Knock No [0]
Dual Trip No [0]
Normally Open No [0]
Walk Test No [0]
Monitor Activity No [0]
Special Log No [0]
Paired Input No [0]
Confirm Group [00]
Input Description
Enter Name Input 01
Enter Location _
ASSIGN KEYPADS/READERS
Address
Address [0]: Keypad [1]
Other Addresses: Unused [0]
Set Point Sets Area A
Set Point Unsets Area A
Set Point In Area A
Set Point Description
Enter Name Device 0
Enter Location
If programmed as Reader:
Reader Is: Set Point [0]
If programmed as Reader, Entry
Control or Access Control
Lock Open Time [005]
Door Open Time [010]
SYSTEM DISPLAYS
All Areas: Text Full Set
Full Area Text Full
Sign on Message Euro One
Site Name _
Display When Set No [0]
Display Alarms No [0]
Display Hus No [0]
Display Inputs No [0]
CHANGE TIMERS
To Next Page
Loading...
