Pyronix Castle EURO 46 Series

EURO 46, 162 & 280 Programming Manual
Page: 41
Engineer Menu’s
Clean Start 2000
(Grade 3)
Clean Start 2002
(Grade 2)
Day Alarm Starts Sirens Only [2]
Day Alarm Stops Sirens Only [2]
CHANGE OUTPUTS
Endstation Outputs
Output 1* Not Used [0000]
Output 2* Not Used [0000]
Strobe O/P Strobe Any [0016]
Bell O/P Siren Any [0014]
XPGM1 O/P** Not Used [0000]
XPGM2 O/P** Not Used [0000]
ATE PIN 1 Fire [0001]
ATE PIN 2 HU Device Any [0009]
ATE PIN 3 Unconfirmed Any [0018]
ATE PIN 4 Final Set All [0004]
ATE PIN 1 Tamper Any [0007]
ATE PIN 1 Omit Rearm Any [0017]
ATE PIN 1 Confirmed Any [0006]
ATE PIN 1 Mains Fail [0052]
ATE PIN 1 Global Fault 2 [0056] Global Fault 1 [0055]
ATE PIN 1 Test ATS [0064]
ZEM Outputs
ZEM Address
Output 1-4 Unused [00]
Wireless Bells
BELL O/P Siren Any [0014]
STB O/P Strobe Any [0016]
Output Module Outputs
OP Mod Address
OP Mod Installed No [0]
Keypad Outputs
Output 1 Unused [0000]
Reader Outputs
Output 1 Unused [0000]
INTELLIGENT SET
Intelligent No [0]
SITE OPTIONS
Set With Fault Yes [1]
Set With Tamper+ No [0] Yes [1]
Set with ATS Fault No [0] Yes [1]
Set Ward TFault Yes [1]
Set Fail = Alarm No [0]
Do Bat Load Test No [0]
Ward Misoperate No [0]
Strb/Sqwk At Set None [0]
Re-Arm Omits No [0]
Use Level Set No [0]
Confirmed When Final Set [0]
Autoset Force No [0]
Restrict PIN Use No [0]
Simple Set No [0]
Invert ATE O/Ps Yes [1]
Common Lobby Yes [1]
Flexi Unset No [0]
2 Key HU None [3]
Extl ATE Inputs None [3]
Tag Opens Doors No [0]
Set with Poll Fault No [0]
Fob Unset Entry Yes [1]
Wireless Bell Supervision Yes [1]
Download if Set No [0]
ENGINEER RESTORE OPTIONS
Engineer Restore Intruder No [0]
Engineer Restore Hold Up No [0]
Engineer Restore Tamper Yes [1] No [0]
Engineer Restore Soak No [0]