Page: 9
CHAPTER 5: SETTING THE ALARM (CODE/TAG)
Enter your user code.
Or
Present a valid tag to the symbol
circled.
Enter the level set you wish to set, and
press the
I key.
‘Please wait arming wireless’ will be
displayed.
There are three different setting
methods your installer will instruct you
through which of these have been
designed into your system.
Final Door: Leave the building and
make sure the exit door is closed
properly.
Timed: Make sure you leave the
building before the timer shown on the
keypad expires.
Push to set: Press the push to set
button installed by your engineer to
arm the system.
SETTING USING A WIRELESS KEYFOB
To set via a keyfob. Press the key
The keyfob LED will start to flash
GREEN indicating that the system is
starting to set.
‘Please wait arming wireless’ will be
displayed on the keypad and the
programmed area will begin to set.
To ‘quick set’, press and hold the ARM
key a second time for 4 seconds.
Once set, the keyfob LED will
illuminate RED indicating that the
system is now set.
To Next Page
Loading...
