32
To use this function, select the option “Enable IPv6” and click “Apply”. The NAS will
restart. After the system restarts, login the IPv6 page again. The settings of the
IPv6 interface will be shown. Click
to edit the settings.
IPv6 Auto Configuration
If you have an IPv6 enabled router on the network, select this option to allow
the NAS to acquire the IPv6 address and the configurations automatically.
Use static IP address
To use a static IP address, enter the IP address (e.g. 2001:bc95:1234:5678),
prefix length (e.g. 64), and the gateway address for the NAS. You may
contact your ISP for the information of the prefix and the prefix length.
Enable Router Advertisement Daemon (radvd)
To configure the NAS as an IPv6 host and distribute IPv6 addresses to the
local clients which support IPv6, enable this option and enter the prefix and
prefix length.
IPv6 DNS server
Enter the preferred DNS server in the upper field and the alternate DNS server
in the lower field. You may contact your ISP or network administrator for the
information. If you select IPv6 auto configuration, leave the fields as “::”.
To Next Page
Loading...
Need help?
General
