34
Enable warning alert for redundant power supply on the web-based
interface:
If you have installed two power supply units (PSU) on the NAS and connected them
to the power sockets, both PSU will supply the power to the NAS (applied to 1U and
2U models). You can enable redundant power supply mode in “System
Administration” > “Hardware” to receive warning alert for the redundant power
supply. The NAS will beep and record the error messages in “System Logs” when
the PSU is plugged out or fails.
If you have installed only one PSU on the NAS, you are suggested NOT to enable this
option.
* This function is disabled by default.
To Next Page
Loading...
Need help?
General
