www.qpcom.com/www.qpcom.com.co
This page is used to configure the parameters for wireless LAN clients witch may connect to your
Access Point. Here you may change wireless encryption settings as well as wireless network parameters.
Wireless Basic Settings
Band:
Mode:
Network Type:
SSID:
Channel Width:
ControlSideband:
Channel Number:
Broadcast SSID:
WMM:
Date Rate:
Associated Clients:
2.4 Ghz (B+G+N)
AP
40MHZ
Upper
Auto
Enabled
Enabled
11
Infraestructure
AP
Disable Wireless LAN Interface
Show Active Client
Enable Mac Clone (Single Ethernet Client)
Enable Universal Repeater Mode (Acting as AP and client simultaneonly)
SSID of Extended Interface:
Apply Changes Reset
To Previous Page
Loading...
Need help?
General