PowerLight 9.0
PFC
, PowerLight 6.0
PFC
, PowerLight 6.0 II Service Manual 61
Parts lists
RE-210001-BM 10.0K, 1 PCNT, 1/4W, METAL FILM, , 4 R9–R12
RE-224902-10 24.9K, 1 PCNT, 1/4W, METAL FILM, , 1 R28
RE-230103-10 30.1K, 1 PCNT, 1/4W, METAL FILM, , 2 R39, R40
RE-247003-00 47K, 5 PCNT, 2W, METAL OXIDE FP, , 1 (TWO DIFFERENT PREP.) R31
RE-247003-00 47K, 5 PCNT, 2W, METAL OXIDE FP, , 2 R3, R4
RE-290900-10 90.9K, 1 PCNT, 1/4W, METAL FILM, , 2 R41, R42
RE-310005-BC 100K, 5 PCNT, 1/4W, CARBON FILM, , 2 R19, R23
RE-312101-BM 121K, 1 PCNT, 1/4W, METAL FILM, , 2 R44, R45
RE-333201-10 332K, 1 PCNT, 1/3W, METAL FILM, , 2 R21, R25
RE-336500-10 365K, 1 PCNT, 1/4W, METAL FILM, , 1 R43
RE-347503-10 475K, 1 PCNT, 1/4W, METAL FILM, , 2 R26, R27
SC-060060-PS PHILLIPS, SEMS EXTERNAL TOOTH, #6-32, 0.375" L, ZINC, 8 RER: Q1-4
SC-060061-PP PHILLIPS, PANHEAD, #6-32, 0.375" L, BLACK, 12 T1,L1 GET THIS SCREW FROM TOUCH UP T22
SC-060121-PP PHILLIPS, PANHEAD, #6-32, 0.75" L, BLACK, 2
SC-061081-PP PHILLIPS, PANHEAD, #6, 0.375" L, ZINC, TYPE B 5
SC-080122-HC HEX, CAP, #8-32, 0.75" L, BLACK, 12 D1,2,D7,8,12,D14,16,17,D19-22
WC-0.3514-JW JUMPER, BARE, 14 AWG SOLID, 1 CONDUCTOR, , 0.35" L, 2 W7, W9
WC-000091-00 JUMPER, COPPER FOIL AND KAPTON, 0.3" X 0.003", 1 CONDUCTOR, PL9.0, 4.9" L, 1 ROUTE THRU C21,22 W5
WC-000092-00 JUMPER, COPPER FOIL AND KAPTON, 0.3" X 0.003", 1 CONDUCTOR, PL9.0, 1.4" L, 4 REF ASSY DRAWING W1–W4
WC-000093-00 JUMPER, COPPER FOIL AND KAPTON, 0.3" X 0.003", 1 CONDUCTOR, PL9.0, 4.3" L, 1 ROUTE THRU C21,22 W6
WC-000106-00 CABLE ASSY, 60 DEGREE PTC, 22 AWG, 2 CONDUCTOR, PL9.0, 8" L, 2 FROM HEATSINK TO J202
WC-000109-00 RIBBON CABLE ASSY, GATE DRIVER, 24 AWG, 8 CONDUCTOR, PL9.0, 16" L, 1 FROM J200 TO J101 ON CONTROL PCB
WC-000125-00 CABLE ASSY, DC OUTPUT, 10 AWG, 5 CONDUCTOR, PL9.0, 6" L, 1 E5-9(0-E9,1-E8,2-E7,3-E6,4-E5) FOLK TERMINAL FACE-UP
WC-000130-00 CABLE ASSY, POWER SUPPLY/AMP, 24 AWG, 8 CONDUCTOR, PL9.0, 9.5" L, 1 FROM CONTROL PCB J100 TO AMP PCB
WC-000133-00 JUMPER, TEFLON INSULATION, 16 AWG SOLID, 1 CONDUCTOR, , 1.75" L, 2 T2,3
WC-000137-00 JUMPER, PVC INSULATION, 14 AWG, 1 CONDUCTOR, , 1.3" L, 3 W11–W13
WC-2.5218-JW JUMPER, TEFLON INSULATION, 18 AWG, 1 CONDUCTOR, , 2.5" L, 0.250" LEAD LENGTH 1 W8
WP-000056-00 FET ASSY, MATCHED, PL6.0/PL9.0, , 1 Q1-4 USE THE SCREWS IN THE PACKAGE TO ASSEMBLE THE HEATSINK TO PCB
WP-000174-00 PCB ASSY, PS CONTROLLER, PL9.0, , 1
XF-000039-00 TRANSFORMER, SWITCHING, 100KHZ, , 4000W, PL9.0, , 1 T1
XF-000041-00 INDUCTOR, POWER, , 45UH, PL9.0, 120V, 1 L1
XF-000042-00 INDUCTOR, COMMON MODE, TOROID, , PL9.0, , 1 L2
XF-000077-00 INDUCTOR, CURRENT SENSE, TOROID, 100TURN, PL9.0, , 2 CUT AND REMOVE GRAY WIRES T2, T3
Power Supply Assembly (QSC part # WP-000180-00)
Where used: PowerLight 9.0
PFC
, 230 volts.
This is a subassembly of the Chassis Assembly, WP-000170-02; two per amplifier.
QSC Part # Description Qty Comments Reference
CA-147100-BD 470PF, 10 PCNT, 100V, CERAMIC Y5F, DISC, 4 C1–C4
CA-210007-00 0.001UF, 5 PCNT, 500V, MICA, DIPPED, 4 C27, C29, C33, C35
CA-222004-00 0.0022UF, 5 PCNT, 500V, MICA, DIPPED, 2 C40, C41
CA-247001-00 0.0047UF, 5 PCNT, 500V, MICA, DIPPED, 2 C44, C45
CA-310001-10 0.01UF, 10 PCNT, 100V, FILM, DIPPED, 1 C7
CA-347400-BP 0.047UF, 10 PCNT, 400V, FILM, DIPPED, 4 C13,18 NEED TO BE LAID FLAT ON THE PCB C13, C18, C23, C37
CA-410009-00 0.1UF, 5 PCNT, 250V, FILM, WRAPPED, 1 VERTICAL PREP/ USE .050 SPACER C20
CA-422001-10 0.22UF, 5 PCNT, 50V, FILM, DIPPED, LOW PROFILE 4 C47–C50
CA-510001-10 1.0UF, 20 PCNT, 50V, CERAMIC Z5U, DIPPED, 4 C5, C9, C14, C16
CA-550001-00 5.0UF, 10 PCNT, 250V, FILM, WRAPPED, HIGH FREQ LOW ESR 2 USE .1000 SPACER C43, C46
CA-568001-00 6.8UF, 10 PCNT, 400V, FILM, WRAPPED, 4 USE .1000 SPACER (PREP AT VERT. POSITION) C21, C22, C24, C31
CA-610004-00 10UF, 20 PCNT, 25V, ELECTROLYTIC, , LOW PROFILE 2 C6, C10
CA-922002-00 22000UF, 20 PCNT, 50V, ELECTROLYTIC, , 8 C26, C28, C30, C32, C34,
C36, C39, C42
CH-000076-00 HEAT SINK, PS, FET, PL9.0, 1
CH-000077-00 HEAT SINK, DIODE, , PL9.0, 1
CH-000089-00 CLAMP, DIODE, 1 FINGER, PL9.0, 12
CO-000074-00 HEADER, 0.1" CENTERS, 8 POS (1X8), MALE, RAMP LOCK 1 J202
CO-000122-00 HEADER, 0.1" CENTERS, 8 POS (1X8), MALE, RIGHT ANGLE RAMP LOCK 1 J200
HW-000007-HW FUSE CLIP, PC MOUNT, , , TIN PLATED BRASS, 5MM 2 F1
Power Supply Assembly WP-000173-02 (continued)
QSC Part # Description Qty Comments Ref erence
To Next Page
Loading...
