BMC CONFIGURATION GROUP
3-43
The fields of PEF Management – Event Filter Tab are explained below.
This page contains the list of configured PEF’s.
Procedure:
1. Click the Event Filter Tab to configure the event filters in the available slots.
2. To Add an Event Filter entry, select a free slot and click Add or alternatively double
click the empty slot to open the Add event Filter entry Page. A sample screenshot of
Add Event Filter Page is shown below.
Figure 3-26. Add Event Filter Entry Page
3. In the Event Filter Configuration section,
PEF ID displays the ID for configured PEF entry (read-only).
In Filter Configuration, check the box to enable the PEF settings.
In Event Severity, select any one of the Event severity from the list.
4. In the Filter Action configuration section,
Event Filter Action is a mandatory field and checked by default, which enable PEF
Alert action (read-only).
Table 16: PET Management - Event Filter
ITEM DESCRIPTION
PEF ID This field displays the ID for the newly configured PEF entry (read-only).
Filter configuration Check box to enable the PEF settings.
Event Filter Action Check box to enable PEF Alert action. This is a mandatory field.
Event Severity To choose any one of the Event severity from the list.
Sensor Name To choose the particular sensor from the sensor list.
Add To add the new event filter entry and return to Event filter list.
Modify To modify the existing entries.
Delete To delete Event filter list.
To Next Page
Loading...
Need help?
General
