BMC CONFIGURATION GROUP
3-66
Virtual Media
In MegaRAC GUI, this page is to configure Virtual Media device settings. If you change the
configuration of the virtual media in this page, it shows the appropriate device in the
JViewer Vmedia dialog. For example, if you select two floppy devices in Configure Virtual
Media page, then in JViewer > Vmedia, you can view two floppy device panel, these vir-
tual media devices will only setup when Launching the KVM.
To open Virtual Media page, click Configuration > Virtual Media from the main menu. A
sample screenshot of User Management Page is shown in the screenshot below.
Figure 3-42. Configure Virtual Media Devices
The following fields are displayed in this page.
Table 28: Configure Virtual Media Devices
ITEM DESCRIPTION
Floppy devices
The number of floppy devices that support for Virtual Media redirec-
tion.
CD/DVD devices
The number of CD/DVD devices that support for Virtual Media redirec-
tion.
Hard disk devices
The number of hard disk devices that support for Virtual Media redirec-
tion.
Remote KVM Floppy Devices
The number of floppy devices that support for KVM Virtual Media redi-
rection.
Remote KVM CD/DVD Devices
The number of CD/DVD devices that support for KVM Virtual Media
redirection.
Remote KVM Hard disk Devices
The number of Hard disk devices that support for KVM Virtual Media
redirection.
Save To save the configured settings.
Reset To reset the previously-saved values.
To Next Page
Loading...
Need help?
General
