BMC CONFIGURATION GROUP
3-49
Procedure:
1. In the LAN Destination Tab, choose the slot to be configured. This should be the
same slot that you have selected in the Alert Policy Entry- Destination Selector field.
That is if you have chosen the Destination Selector as 4 in the Alert Policy Entry page
of Alert Policy Tab, then you have to configure the 4th slot of LAN Destination Page.
2. Double click on the slot and click Add. This opens the Add LAN Destination entry.
Figure 3-30. Add LAN Destination entry Page
3. In the LAN Channel Number field, the LAN Channel Number for the selected slot is
displayed and this is a read-only field.
Subject & Message
These fields must be configured if e-mail alert is chosen as destination
type with the user configured in FixedSubject-Format. If the selected
user for mail alert is configured with AMI-Format then the Subject and
message fields will be greyed out. An e-mail will be sent to the config-
ured e-mail address in case of any severity events with a subject speci-
fied in subject field and will contain the message field's content as the
e-mail body.
User should be configured under Configuration-->Users
Send Test Alert
These fields must be configured if email alert or SNMP Trap is chosen as
destination type. This field will send a test message in the message
field's content to specified destination.
Add
To add a new entry to the device. Alternatively, double click on a free
slot.
Modify To modify that entry. Alternatively, double click on the configured slot.
Delete To delete the selected configured LAN destination.
Table 18: PEF Management - LAN Destination (Continued)
ITEM DESCRIPTION