General Mode CLI Command List ScreenFigure 4-2:
On the prompt, input “6. enable” to enable the Privilege mode.Inthismode,youcancongure
the IP address and execute other advanced CLI commands (see “CLI Documentation” for more
information).
On the prompt, input “7. congure”. The prompt changes to “(Quanta) (Cong) #”.
Set the service port IP addres (in the example below, the service port IP address is set to 8.
192.168.2.1)
Congure
Serviceport protocol none
Serviceport ip 192.168.2.1 255.255.255.0
exit
Set Service Port IP ScreenFigure 4-3:
Input “9. ip default-gateway <gateway>” (where <gateway> is a value between 0.0.0.0 to
255.255.255.255).
From this point, the IP address, subnet mask, and gateway of the switch has been set. On the 10.
command prompt, input “exit” to go back one level. The prompt changes to “(Quanta) #”.
Input “11. show ip interface”todisplaythenetworkcongurationsoftheswitch.
Obtain IP Address by DHCP4.2.2
When using a DHCP server, the switch obtains an IP address, subnet mask, and default gateway from
the DHCP server. Ask your network administrator to identify the IP address assigned to the switch.
UsethisIPaddresstologintotheWebUtilitytoconguretheswitch.
To Next Page
Loading...
Need help?
General
