Quantronix CUBISCAN 25 - Page 89

Communication Protocol TCP/IP Communications Setup Command Set
CubiScan 25 Service Manual 80
Read Gateway Address
This command is used to read the current gateway address setting from the CubiScan 25.
Pos Len Description Type Range ASCII
Command Format
1 1 Start of Text Control (STX) 02h
2 1 Read Command Alpha (~) 7Eh
31
Gateway Address
Command
Alpha (G) 47h
4 1 End of Text Control (ETX) 03h
5 1 Carriage Return Control (CR) 0Dh
6 1 Line Feed Control (LF) 0Ah
Acknowledge Format
1 1 Start of Text Control (STX) 02h
2 1 Read Command Alpha (~) 7Eh
31
Gateway Address
Command
Alpha (G) 47h
4 1 Acknowledge Alpha (A) 41h
5
7-15
or n
IP Address Alpha
(0.0.0.0) to
(255.255.255.25
5)
5+n 1 End of Text Control (ETX) 03h
6+n 1 Carriage Return Control (CR) 0Dh
7+n 1 Line Feed Control (LF) 0Ah
Negative Acknowledge Format
Pos Len Description Type Range ASCII
1 1 Start of Text Control (STX) 02h
2 1 Read Command Alpha (~) 7Eh
31
Gateway Address
Command
Alpha (G) 47h
4 1 Neg. Acknowledge Alpha (N) 4Eh
5 1 End of Text Control (ETX) 03h
6 1 Carriage Return Control (CR) 0Dh
7 1 Line Feed Control (LF) 0Ah