Operation
Intelligent Electric Vehicle Chargepoints QUBEVSM-V01-R0 Installation and Operation Manual
Page 31 of 42 February 2023
OCPP IP and ID Settings
If required, the IP address of the OCPP back-office server can be set/changed.
These settings must NOT be amended unless instructed to do so.
1. Make sure the OCPP IP address is correct.
2. Make sure the ID is entered exactly as shown on the OCPP server.
x The Device number field will update to be the same as the ID on the OCPP server
but may not change until the system is restarted.
3. After entering changes, exit the application then power off the charger. Restart the
charger and check that the changes have taken effect.
Operation
IMPORTANT: This chargepoint is designed to be used by adults only, do not allow children to
operate or play with the appliance.
NOTE: At the end of a charging session, always disconnect the cable from the vehicle before
disconnecting from the charger.
Share a Connection
Only one account can be registered to a charger.
If other people (guests) also need to use the charger without the owner being present, they must
have their own account with the application. The owner can then share controlled access to the
charger through an ‘invitation’ to specific people.
1. Tap the Pencil icon at the top of the screen.
2. Tap the Share Device text.
x If this is the first time the charger has been shared, you may be required to tap the
Add Sharing button.
3. On the next screen, enter the number of people the access to the charger will be shared
with.
4. Choose the method of sharing – this is governed by the methods of sharing already
provided by your phone. Some common options may be displayed as standard. Other
options will be accessible by tapping the More button.
x A message with a link to access the charger will be written into the chosen sharing
application.
5. When the message is received, the guest should follow the onscreen prompts to access
and connect to the charger.
x When first added, the screen may need to be refreshed for the charger to be
displayed.
6. From this point you can use the chargepoint for charging, but you cannot access
important settings.