qubev smart EVON0090 - Electrical Specifications and Compliance; Certifications and Compliances

Product Specification
QUBEVSM-V01-R0 Installation and Operation Manual Intelligent Electric Vehicle Chargepoints
February 2023 Page 8 of 42
Electrical Specification
EVON0090 EVON0095 EVON0100 EVON0105
Description Single
Socket,
Intelligent
EV Charging
Unit
5m Tethered
Cable,
Intelligent
EV Charging
Unit
Single
Socket,
Intelligent
EV Charging
Unit
5m Tethered
Cable,
Intelligent
EV Charging
Unit
Rated Output Up to 7.4kW (32A) Up to 22kW (32A)
Rated Current Up to 32A max
DC Fault Protection Type A 30mA, DC 6mA
Charging Current Variable – 10A, 13A, 16A, & 32A
Input Voltage
AC 220V~240V 50/60Hz
(1-phase)
AC380V~415V 50/60Hz
(3-phase)
Incoming Cable Terminals 3 x 10mm2 terminals 5 x 10mm2 terminals
Overcurrent Protection Recommended 40A
Charging Connection IEC 62196 (Type 2)
Charge Protocol Mode 3
NOTES:
1. A Type ‘A’ Residual Current Circuit Breaker (RCBO) installed at source is recommended.
2. Tethered cables are approximately 5m total length.
Certifications and Compliances
This product has been designed and built in accordance with the following standards and
legislation:
EV Charging Compliance EN IEC 61851-1:2019, BS EN IEC 61851-1:2019.
Smart Regulations SI 2021:1467 inc Schedule 1.
EMC Compliance
2014/30/EU, SI 2016:1091.
ETSI EN 301 489-1 V2.2.3 (2019-11) ETSI EN 301 489-3 V2.1.1
(2019-03), ETSI EN 301 489-17 V3.2.4 (2020-09).
IEC 61851-21-2:2018.
EN IEC 61851-21-2:2021.
Radio Emissions
2014/53/EU, SI 2021:1467.
ETSI EN 300 328 V2.2.2, ETSI EN 300 330 V2.1.1.
ETSI EN 301 489-1 V2.2.3, ETSI EN 301 489-3 V2.1.1.
ETSI EN 301 489-17 V3.2.4, EN IEC 61851-21-2:2021.
EN IEC 61851-1:2019, EN IEC 62311:2020.
BS EN IEC 61851-21-2:2021, BS EN IEC 62311:2020.
Safety Compliance
EN 60950-1:2006+A2:2013, EN 60950-22:2017.
IEC 62955:2018.
Low Voltage Directive (LVD) 2014/35/EU, SI 2016:1101.