How to increase video footage storage on Queclink CV100LG?
If there is only a small amount of video footage stored on your TF card for Queclink Dash Cameras, replace it with larger capacity TF card, MAX.128GB.
Why can't my Queclink CV100LG receive GPS signal?
If your Queclink Dash Camera cannot receive a GPS signal, it could be due to being in an out-of-service area, being surrounded by tall buildings, or experiencing storms or heavy rain. Try again on a clear day in an area known for good GPS reception. Note that it can take 3-5 minutes to establish a GPS connection.
What to do if my Queclink CV100LG cannot power on?
If your Queclink Dash Camera won't power on, ensure the power cable (Battery +, ACC_IN, GND) is properly connected to the vehicle’s fuse box. Check the vehicle’s battery level and the product's over-discharge settings. Also, inspect the Battery+ and ACC_IN cables' fuses; if blown, replace them with the same type (2amp).
How to fix Queclink CV100LG Dash Cameras video with no sound?
If your Queclink Dash Camera video has no sound, ensure that the 'Record Audio' setting is turned ON within the Setup menu of the product.
How to fix blurred video image on Queclink CV100LG?
If the video image from your Queclink Dash Camera is blurred, remove the protective lens cover, ensure the product's field of view doesn't include any painted section of the windscreen, and clean both the lens and the windscreen. Check the installation location of the front or interior camera, turn on the product, and then adjust the camera's viewing angle.
What to do for unknown issues with Queclink CV100LG?
If you encounter unknown and unsolved issues with your Queclink Dash Camera, reset the product to the Default Settings within the Setup Menu and try again.
Why can't I get video view in QuCam app with Queclink CV100LG Dash Cameras?
If you cannot get the video view when trying to play back a file from your Queclink Dash Camera by Wi-Fi mode, please restart your mobile device and reconnect to the product’s Wi-Fi network, then re-open the QuCam mobile app. Please re-fresh the video thumbnails and select the desired video to playback again.
How to reset Wi-Fi password on Queclink CV100LG Dash Cameras?
If you have forgotten your password for the Wi-Fi connection on your Queclink Dash Camera, open the Wi-Fi setting to re-configure the parameters.
Why is CELL indicator flashing quickly on Queclink CV100LG Dash Cameras?
If the CELL indicator keeps flashing quickly on your Queclink Dash Camera, check the signal strength using the mobile app and move the product to a better open location. Confirm with your ISP that the SIM card is active and verify the APN settings with the correct parameters.
What to do if back-end server cannot receive reports from Queclink Dash Cameras?
If the back-end server cannot receive any reports from your Queclink Dash Camera, make sure the product is accessible to the internet, the report server is running well, and the report server parameters are configured properly.
General| LTE Cat M1/NB1 | Yes |
|---|---|
| Video Resolution | 1080P |
| Field of View | 140° |
| GPS | Yes |
| G-Sensor | Yes |
| Operating Temperature | -20°C to +70°C |
| GNSS | Yes |
| Cellular Antenna | Internal |
| GNSS Antenna | Internal |
| Accelerometer | Yes |
| SIM | Nano-SIM |
| Storage | MicroSD up to 128GB |
To Next Page