Queclink GL300 - Page 56

GL300 @Tracker Air Interface Protocol
<ODO enable> was set as 0 in the command AT+GTCFG, the field will be empty.
 <battery percentage>: The current volume of the battery in percentage.
3.3.1.2. Location by Call Report
 +RESP:GTLBC:
Example:
+RESP:GTLBC,1A0102,135790246811220,,+8613800000000,1,4.3,92,70.0,121.354335,31.2
22073,20090214013254,0460,0000,18d8,6141,00,,20090214093254,11F0$
Parameter Length (byte) Range/Format Default
Protocol version 6 XX0000 – XXFFFF,
X∈{'A'-'Z','0'-'9'}
Unique ID 15 IMEI
Device name 20
Call number <=20 phone number
GPS accuracy <=2 0|1 – 50
Speed <=5 0.0 – 999.9km/h
Azimuth <=3 0 – 359
Altitude <=8 ±XXXXX.X m
Longitude <=11 ±XXX.XXXXXX
Latitude <=10 ±XX.XXXXXX
GPS UTC time 14 YYYYMMDDHHMMSS
MCC 4 0XXX
MNC 4 0XXX
LAC 4 XXXX
Cell ID 4 XXXX
Odo mileage 9 0.0 – 4294967.0Km
Reserved2 0
Send time 14 YYYYMMDDHHMMSS
Count number 4 0000 – FFFF
Tail character 1 $ $
 <Call number>: the phone number of the incoming call which initiates this report.
3.3.1.3. Location as centre of Geo-Fence
If functi
on ke
y mode was set as 2 and long press function key to switch on Geo-Fence 0, the
terminal will start GPS fixing to get the current position as the centre of Geo-Fence 0. And after
GPS fixing finishes, the terminal will report the message +RESP:GTGCR.
 +RESP:GTGCR:
Example:
+RESP:GTGCR,1A0102,135790246811220,,3,50,180,2,0.4,296,-5.4,121.391055,31.164473,2
TRACGL300AN001 - 55 -
Queclink
Confidential