Queclink GL300 - Revision History

GL300 @Tracker Air Interface Protocol
0. Revision history
Revision Date Author Description of change
0.02 2012-10-12 Evan.tu Initial
1.00 2012-10-26
2012-11-12
2012-11-14
2012-11-16
2012-11-19
2012-11-20
2012-11-26
2012-11-28
2012-11-29
2012-12-04
2012-12-15
2013-1-5
2013-1-9
2013-1-15
Evan.Tu
Evan.Tu
Evan.Tu
Evan.Tu
Evan.Tu
Evan.Tu
Evan.Tu
Evan.Tu
Evan.Tu
Evan.Tu
Evan.Tu
Evan.Tu
Evan.Tu
Evan.Tu
Evan.Tu
Evan.Tu
1. Add a new parameter to control whether to drive
the motor in the command “AT+GTFKS”
2. Add a new command “AT+GTMON”
3.Delete the command “AT+GTFFC” protocol
4.Modified the command “AT+GTRTO” protocol
5.Modified the command “AT+GTOWH” protocol
6.Delete the report massage “+RESP:GTANT”
7.Add the report massage “+RESP:GTALS”
8.Add 4 reserved parameter in the command
“AT+GTOWH”
9.Modified the parameter <log enable> is reserved
in the commands “AT+GTQSS 、AT+GTBSI”
10.Modified the report massage “+RESP:GTDOG”
11.Modified the description of NOTE in the
command “AT+GTFRI”
12.Add the report massage “+RESP:GTDAT”
13.Add a parameter <GSM Interval> in the
command “AT+GTNTS”
14.Modified the report massage “+RESP：GTALL”
15.Modified the report massage “+RESP:GTDOG”
16.Modified the decription of the parameter<
Power
key ind
> in command “AT+GTFKS”
17.Add the report massage “+RESP:GTMON”
18.Add the temperature alarm report function
AT+GTTEM and the alarm report massage
+RESP:GTTEM
19.Add a parameter <temperature> in the report
massage +RESP:GTINF
20.Modified the report massage “+RESP:GTMON”
2013-07-24
Evan.Tu
1.Add two new commands “AT + GTCMD” and
“AT + GTUDF”
2.Add two new parameters <SMS ACK Enable>
and <quick link enable> in the command
“AT+GTSRI”
2013-08-28 Evan.Tu 1.Add a new protocol command AT + GTUPC
1.01
2013-08-30 Evan.Tu 1.Delete a protocol command AT + GTMON
1.02 2013-10-17 Evan.Tu 1.Add the report mode 6 in the command
AT+GTQSS
TRACGL300AN001 - 6 -
Queclink
Confidential