Quectel BC26 - Page 45

NB-IoT Module Series
BC26 AT Commands Manual
BC26_AT_Commands_Manual 45 / 73
This command name is temporary and may be changed in the future release.
0 Deactivation requirement
1 Activation requirement
<pdp_type/cid> Integer type;
If <op> is 0, it is pdp_type. Otherwise, it is cid.
pdp_type: It is the pdp_type wanted to activate.
1 IPv4
2 IPv6
3 IPv4v6
4 Non-IP
cid: It is a numeric parameter specifying a particular PDP context. Here it should
be equal to the <cid> returned by the activation response.
<apn> It is the access point name which is mandatory for the activation requirement
and should be omitted for the deactivation requirement.
<user_name> It is the user name for access to the IP network which is mandatory for the
activation requirement and should be omitted for the deactivation
requirement.
<pwd> It is the password for access to the IP network which is mandatory for the
activation requirement and should be omitted for the deactivation
requirement.
<bearer_type> It is the type of bearer wanted to activate which is optional for the activation
requirement and should be omitted for the deactivation requirement.
1 NBIOT (Only NBIOT is supported currently)
<sim_id> It is the id of the SIM Card wanted to use which is optional for the activation
requirement and should be omitted for the deactivation requirement.
1 SIM Card 1 (Only SIM Card 1 is supported currently).
<cid> It is a numeric parameter specifying a particular PDP context.
<type> 0 Result/URC for deactivation requirement
1 Result/URC for activation requirement
2 URC for passive deactivation
<result> 0 failure
1 success
<activated_pdp_type> It is the pdp_type actually activated.
1 IPv4
2 IPv6
3 IPv4v6
4 Non-IP
NOTES