Quectel BG96 - Page 73

Section Parameter Definition
simple (default) – Report only the content of the state reported
object
complete – Report the complete JSON data
off – Do not report a set value
For more information, see EMQPERSIST – report a set value to the
device shadow on page46.
clientid MQTT client ID
If this parameter is not set, it is not included in the
configuration file.
keepalive Maximum expected time (in seconds) between received keepalives
before ETM assumes the MQTT connection is down. Default: 1200
mqttlwtmessage LWT message for notifying subscribed clients about an unexpected
loss of connection. To enable LWT, you must configure
mqttlwttopic and mqttlwtmessage. Use:
<message> – the MQTT message that is discarded if the client
disconnects gracefully
If this parameter is not set, it is not included in the
configuration file.
mqttlwtqos Last will and testament (LWT) message QoS, defining the
guarantee of message delivery. Either:
0 (default) – at most once, no guarantee of message delivery
1 – the message is sent or delivered to the receiver one or more
times
mqttlwtretain LWT message retained message flag, either:
0 (default) – message flag not enabled. This is a required setting
for AWS only.
1 – message flag enabled
mqttlwttopic Last will and testament (LWT) topic path for notifying subscribed
clients about an unexpected loss of connection. To enable LWT,
you must configure mqttlwttopic and mqttlwtmessage. Use:
<topic> – the topic path
If this parameter is not set, it is not included in the
Eseye-enabled Quectel BG96 module Developer Guide v1.8
66
Using the Quectel BG96 module configuration file