EasyManua.ls Logo

Quectel RM520N-GL - Introduction

Quectel RM520N-GL
88 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5G Module Series
RM520N-GL_Hardware_Design 10 / 84
Figure Index
Figure 1: Functional Diagram ..................................................................................................................... 20
Figure 2: Pin Assignment ........................................................................................................................... 21
Figure 3: DRX Run Time and Current Consumption in Sleep Mode ......................................................... 28
Figure 4: Sleep Mode Application with USB Remote Wakeup .................................................................. 28
Figure 5: Power Supply Limits during Radio Transmission ....................................................................... 30
Figure 6: Reference Circuit for VCC .......................................................................................................... 31
Figure 7: Reference Circuit for Power Supply ........................................................................................... 31
Figure 8: Turn on the Module with a Host GPIO ........................................................................................ 33
Figure 9: Turn-on Timing of the Module ..................................................................................................... 33
Figure 10: Turn-off Timing through FULL_CARD_POWER_OFF# ........................................................... 35
Figure 11: Reference Circuit of RESET# with NPN Driver Circuit ............................................................. 36
Figure 12: Reference Circuit of RESET# with a Button ............................................................................. 36
Figure 13: Reset Timing of the Module’s Warm Reset .............................................................................. 37
Figure 14: Reset Timing of the Module’s Hard Reset ................................................................................ 38
Figure 15: Reference Circuit for Normally Closed (U)SIM Card Connector .............................................. 41
Figure 16: Reference Circuit for Normally Open (U)SIM Card Connector ................................................ 42
Figure 17: Reference Circuit for a 6-Pin (U)SIM Card Connector ............................................................. 43
Figure 18: Recommended Compatible Design for (U)SIM2 Interface ....................................................... 43
Figure 19: Reference Circuit of USB 3.1 & 2.0 Interface ........................................................................... 45
Figure 20: PCIe Interface Reference Circuit .............................................................................................. 48
Figure 21: W_DISABLE1# and W_DISABLE2# Reference Circuit ........................................................... 51
Figure 22: LED_WWAN# Reference Circuit .............................................................................................. 52
Figure 23: WAKE_ON_WAN# Signal Reference Circuit ........................................................................... 53
Figure 24: Recommended Circuit of Configuration Pins ........................................................................... 55
Figure 25: RF Connector Dimensions (Unit: mm) ...................................................................................... 62
Figure 26: RM520N-GL Antenna Connectors ............................................................................................ 63
Figure 27: Specifications of Mating Plugs Using Ø 0.81 mm Coaxial Cables ........................................... 64
Figure 28: Connection Between RF Connector and Mating Plug Using Ø 0.81 mm Coaxial Cable......... 64
Figure 29: Connection Between RF Connector and Mating Plug Using Ø 1.13 mm Coaxial Cable......... 65
Figure 30: Plug in a Coaxial Cable Plug .................................................................................................... 65
Figure 31: Pull out a Coaxial Cable Plug ................................................................................................... 66
Figure 32: Install the Coaxial Cable Plug with A Jig .................................................................................. 66
Figure 33: Thermal Dissipation Area Inside and on Bottom Side of the Module ...................................... 72
Figure 34: Placement and Fixing of the Heatsink ...................................................................................... 73
Figure 35: Mechanical Dimensions of the Module (Unit: mm) ................................................................... 75
Figure 36: RM520N-GL Top and Bottom Views ........................................................................................ 76
Figure 37: Blister Tray Dimension Drawing ............................................................................................... 77
Figure 38: Packaging Process ................................................................................................................... 78

Table of Contents