RACOM RipEX - Page 193

■ Monitoring examples
Monitoring examples - COM, RADIO
The hexadecimal data aaaa is coming through the port COM1 and then the frame is sent over
the radio channel. Monitored on IP address 192.168.141.213:
07:55:04.661446 [COM1:phy:Rx] length 2
0x0000: aaaa
07:55:04.674861 [RF:phy:Tx] (88) IP 192.168.141.213.8881>192.168.141.214.8882: UDP,length 32
0x0000: 0800 4500 001e 0000 4000 4011 9dd2 c0a8
0x0010: 8dd5 c0a8 8dd6 22b1 22b2 000a 72cf aaaa
07:55:04.661446 timestamp -
it is recommended to synchronize time in the network (e.g. using
NTP server) to be able to analyse records from multiple units
[COM1:phy:Rx] (MP1) interface monitored -
COM port 1: physical layer : frame received from an external device
length 2 monitored frame length [bytes]
0x0000: monitored frame position, Byte increments, hexadecimal
aaaa monitored frame
07:55:04.674861 timestamp
[RF:phy:Tx] (MP4) interface monitored -
RADIO channel : physical layer : frame transmitted to the antenna
(88) physical layer Tx frame number
IP 192.168.141.213.8881> SRC IP address and UDP port number
192.168.141.214.8882: DST IP address and UDP port number
UDP Ethernet Protocol type
length 32 monitored frame length [bytes]
0x0000: monitored frame report position, Byte increments, hexadecimal
0800 4500 001e 0000 4000
4011 9dd2 c0a8
monitored frame report
NOTE: (MP1),(MP4) are the monitoring points as described in Fig. 7.13, “Interfaces”
193© RACOM s.r.o. – RipEX Radio modem & Router
Advanced Configuration