RACOM RipEX - Page 57

Modbus TCP, IEC104, DNP3 TCP, Comli TCP, Terminal server…User protocols on Ethernet
Modbus RTU / Modbus TCP, DNP3 / DNP3 TCPSerial to IP convertors
Protocol on Radio channel
YesMulti master applications
YesReport by exception
YesCollision Avoidance Capability
YesRemote to Remote communication
Yes
Addressed & acknowledged serial
SCADA protocols
CRC 32Data integrity control
AES256Encryption
up to 3× higher throughputOptimization
Diagnostic and Management
Yes (ping with RSS, Data Quality, Homogeneity)Radio link testing
Device – Ucc, Temp, PWR, VSWR, *HW Alarm Input.
Radio channel – *RSScom, *DQcom, TXLost[%]
User interfaces – ETH[Rx/Tx], COM1[Rx/Tx], COM2[Rx/Tx]
* not broadcast
Watched values (Can be broadcast
to neighbouring units. Received info
displayed in Neighbours table)
For Rx/Tx Packets on User interfaces (ETH, COM1, COM2) and
for User data and Radio protocol (Repeats, Lost, ACK etc.) on
Radio channel
Statistics
For Watched values and StatisticsGraphs
20 periods (configurable, e.g. days)History (Statistics, Neighbours,
Graphs)
SNMPv1, SNMPv2c, SNMPv3
Trap / Inform alarms generation as per settings
SNMP
Real time/Save to file analysis of all physical interfaces (RADIO,
ETH, COM1, COM2) and some internal interfaces between
Monitoring
software modules (e.g. Terminal servers, Modbus TCP server
etc.)
57© RACOM s.r.o. – RipEX Radio modem & Router
Product