(3) GPS mode settings
This machine is equipped with a multi-mode GPS module, mainly including GPS from the United States and Beidou from China.
Set path: [MENU] + 4 + [MENU] + 3: Press the / key to select GPS mode (Beidou, GPS, or GPS+Beidou).
Use of GPS
In standby mode, press and hold [P2] key to enter GPS mode and display "My Place” as an
information list. Press [MENU] key to switch My Place in the information list mode or electronic
compass mode. Press the / key to switch the information of the selected member. The
current Contact sequence will be displayed at the top of the interface.
Press the [EXIT] key to exit GNSS mode
Find My Place
1. Press and hold [P2] key to enter GPS mode.
2. Use the /key to switch to "My Place".
3. At this point, the GPS is in receive mode and displays "Searching" The
GPS character on the right is red, indicating that the positioning has not been successful.
Note: If "Searching" is displayed for a long time, it is recommended that you search
for satellites in an open location.
4. Display "Pos Successful" to indicate that the radios position has been successfully
obtained, and display the current time, longitude, latitude, and altitude, Where N is
north latitude, E is east longitude, and H is height. The GPS character on the right is
green.
5. Press the [MENU] key to switch between the GPS position information interface
and the GPS distance direction interface.
To Next Page
Loading...
