RadioLink Electronic Limited
www.radiolink.com
(1) Enter the function menu and use “Dec(-)” or“Inc(+) ” button to access IDLUP function.
(2) Press “Enter” button to get into IDLUP function interface.
(3) Press “Enter” key, and the initial value of RATE will blink. Use“ Dec(-) ” or “Inc(+)” button to adjust the
value.
(Note: In the interface of adjusting the value, return to the initial value "0%" by pressing “Dec(-)” and “Inc(+)”
buttons simultaneously for about 1 second.)
Press “Enter”button, the adjusted value stops blinking, now the value has been set.
(4) When ending setting, return to the initial screen by pressing “Exit”button twice.
2.11.2 Throttle Lock "TH-LOCK"
In addition to adjusting the throttle speed when the throttle trigger is in the neutral position, the Idle up at
engine start function can also set the throttle lock, select the throttle value
that needs to be locked, and the setting range is -100% to +100%. After the
throttle is locked, no matter the current No matter where the throttle trigger
is, the throttle output will jump to the set value.
This function is controlled by the trigger of the SWA jog switch, press to lock,
press again to unlock, the control switch defaults to SWA and cannot be
modified.
The specific setting method is as follows:
1. Enter the function menu and use the "Dec(-)" or "Inc(+)" key to select
the "TH-LOCK" setting item.
2. Press the "Enter" button to enter the "TH-LOCK" function interface.
3. Move the cursor to "Throttle Lock", press the "Enter" key again, "Throttle Lock" will start to flash, and then
use the "Dec(-)" or "Inc(+)" key to adjust the amount of throttle lock.
4. Press the "Enter" key, the adjusted value stops flashing, and the setting is complete.
5. After setting, press the "Exit" key to return to the initial interface, and press the SWA switch to switch
between locking and unlocking the throttle.
Here is a tutorial of TH-LOCK function: https://www.youtube.com/watch?v=vCEHpUoTLzE
2.12 Sub-trim "SUB-TRIM"
Servo center position adjustment
Use this function to adjust the neutral position of the steering, throttle and all other channel.
Channel
ST: Steering(CH1)
TH: Throttle(CH2)
CH3: Channel3(VR)
CH4: Channel4(SWA)
CH5: Channel5(SWD)
Sub-trim
ST: -100~0~+100
TH: -100~0~+100
CH3: -100~0~+100
CH4: -100~0~+100
To Next Page
Loading...
Need help?
General
