RadioLink Electronic Limited
www.radiolink.com
2.16 Programmable Mixes "PMIX01/02"
Programmable mixes between arbitrary channels
These functions allow you to apply mixing between the steering, throttle, CH3, CH4 and CH5. PMIX01 setting
is the same with PMIX02
Programmable Mixes "PMIX"
MXMD:Mix mode
Enter the function menu and use“Dec(-)”or “Inc(+)” button to access PMIX
function, then press “Enter” button to get into PMIX function interface.
MOD: Mixing mode.
INH: means the mixing function is disabled. Regardless of whether there is
a set control switch or value under this function, it is not enabled.
ON/OFF: means turning the function on and off. Set the mode to ON, the
current mixing control can take effect.
SW: Switch to control the mix function. You can set SWA, SWD, or the lock
modes of these four switch buttons LK-A, LK-D. "NULL" means no switch
assigned. After setting the travel amount of the corresponding channel, the transmitter will always execute the
set value by default.
POS: means the position of the switch used to control this function. UP (up)/DOWN (down): It indicates the
position of the selected switch. Push/Press the switch to different positions to set different travel amount.
LEFT: Mixing rate (Left side)
RIGN: Mixing rate (Right side)
MST: Master channel
SLV: Slave channel
(1) Master channel
Channel selection (MST)
ST, TH, CH3, CH4, CH5
Initial value: ST
Select setup item"MST" by pressing “Dec(-)” or“Inc(+)”button, press“ Enter ” button, the initial master channel
will blink. Use“ Dec(-)”or“ Inc(+) ” button to select the master channel you wish to adjust, press“Enter”
button,the blinking master channel you selected will stop blinking.
(2) Slave channel
Channel selection (SLV)
ST, TH, CH3, CH4, CH5
Initial value: ST
Select setup item "SLV" by pressing “Dec(-)” or “Inc(+)” button, press “Enter” button, the initial slave channel
will blink. Use “Dec(-)” or “Inc(+)”button to select the slave channel you wish to adjust, press “Enter” button,
the blinking slave channel you selected will stop blinking.
(3) Left, forward or up side mixing amount adjustment
Mixing amount
-100~0~+100
Select the setting item "LEFT", "FWRD", or "UP"(These setup items are different depend on the master
To Next Page
Loading...
Need help?
General
