RadioLink Electronic Limited
www.radiolink.com
1.2.4 Gyro Setup
The gyro function of receiver R6FG for professional car drifting can be enabled and disabled. When it’s
enabled, the turning stability can be maximized during competition. When there is false position, gyro function
keeps the car straight forward and turn precisely.
A. Gyro Enabled
Factory setting is gyro function OFF by default.
Short press the binding button (ID SET) three times with interval less than 1 second, the RED indicator
flashes three times. Red LED on/off indicates the gyro function is on/off.
B. Gyro Phase
When the gyro forward is enabled, try to turn the model car to check if the gyro is correcting the wheels.
Normally, the wheels should turn right to correct when the car is turned left while the wheels should turn left to
correct when the car is turned right. If the gyro phase is reversed, short press the binding button (ID SET)
twice with interval less than 1 second. The RED indicator flashes twice means the gyro phase is switched.
C. Gyro Sensitivity Adjustment
The gyro sensitivity can be adjusted in the BASIC MENU-- GYRO in the transmitter. VR and STD modes are
optional. Gyro sensitivity setting is CH3 by default (factory setting) and can be adjusted by VR knob. If VR
knob or channel 3 is used for other functions, select STD mode and adjust the gyro sensitivity by buttons
Dec(-) or Inc(+) . Percentage is displayed when sensitivity is adjusted while the bigger percentage means
higher sensitivity.
1.2.5 Signal/RSSI Real-time Return
Power on the transmitter and the receiver and complete the binding, signal will be displayed on the main
interface of transmitter. Short press EXIT twice and enter the interface with returned information including
RSSI value.
Warning can be set with a certain low RSSI value after testing by changing distance:
Press EXIT and ENTER simultaneously to enter MENU=>press Inc(+) to highlight “19. ALARM” =>Press
ENTER to (dis)activate the warning and set the RSSI warning value.
Note: The 'RATE: RPM' and 'T: NULL' telemetry functions are still under development. If there are new
developments, we will announce them to the RadioLink official website as soon as possible.
To Next Page
Loading...
Need help?
General
