RadioLink Electronic Limited
www.radiolink.com
11
⑤ Push any of the trimmer buttons to stop the DD sounds and the servo range will display on
the APP, meaning connection between the APP and T8FB succeed.
Note:
If there is no servo range display in APP, it means the connection is unsuccessful and you need
to reconnect.
If you cannot find the Bluetooth device with the name “Radiolink” after clicking
“CONNECT”. Please check whether the “Location Information” of your phone is turned on, if
not, please open the “Location Information”;
If the “Location Information” is on, but you still can’t find “Radiolink Bluetooth device”.
Please open the application in the phone --settings-application management--T8S&T8FB
permissions--location information, change the location information from “only allowed during
use” to “Prohibited”, and then change to “allowed only during use”again.
If all the steps above have finished, but the mobile phone parameter setup APP still cannot
connect the transmitter success, please download the version V603.
2.1.3 Mobile Phone APP Parameters Setup Menu
Parameters setup of both Android APP and Apple APP are the same.
The setup menu includes: SERVO, BASIC, ADVANCE, PROG.MIX. After click PROG.MIX, there
are 4 PROG.MIX setting, SYSTEM, TH/CURE, DR/CURE, RESET. For detailed setting method, please
refer to 3.2 Basic Menu.
To Next Page
Loading...
Need help?
General
