RadioLink Electronic Limited
www.radiolink.com
16
3.2 BASIC Menu
3.2.1 REVERSE
This function is to change the direction of the servo in response to the remote controller input.
Make sure to check all servos move to the correct direction as wish under control.
Note: If programmable mix control function is used to control several servos for fixed
wing/gliders, e.g. V-TAIL mix control, make sure to set the phase in advance to avoid possible
confusion.
The interface of parameter setup APP on phone.
The interface of parameter setup software on computer.
After changing the channel phase, please check the control of the corresponding channel on
the model, to make sure the response direction of the channel is correct. Make sure that the
response of each servo with the operation of transmitter is correct.
To Next Page
Loading...
Need help?
General
