RadioLink Electronic Limited
www.radiolink.com
18
3.2.3 END POINT ADJUSTMENT (EPA)
This function is used to set travel range of the servo connected to the channel.
When setting the model or after the first flight, if you feel that the movement of the model is
still relatively small when you move the joystick to the maximum position. You can increase the
travel range percentage of the corresponding channel of the servo (the maximum can be adjusted
to 120, The default is 96). EPA-L and EPA-R respectively represent the travel range on two sides of
the neutral point. You can choose the side you want to modify to adjust travel range percentage.
The interface of parameter setup APP on phone.
The interface of parameter setup software on computer.
3.2.4 FAIL SAFE (F/S)
If the flight has reached the limit control distance, there is strong interference in the flight
area, there are obstacles between the transmitter and the receiver, or T8FB low voltage it will
cause loss of control. At this time, you can set the Fail-Safe, so that the model can maintain
To Next Page
Loading...
Need help?
General
