RadioLink Electronic Limited
www.radiolink.com
29
And the final effect can be seen on the “SERVO MENU” interface.
Note that If you flip any switch and two channels will change, please check whether the two
auxiliary channels are set to the same switch.
Click the auxiliary function of CH5/6/7/8, there will be five options of “SWA”, “SWB”,
“VrA”, “VrB” and “NULL” for selection.” NULL “means no switch control.
The interface of parameter setup APP on phone.
The interface of parameter setup software on computer.
3.4.4.2 ALARM
TX-ALARM
The default low voltage value of transmitter is automatically set according to the battery used.
For 2S lipo battery, it is 7.3V. For 3S lipo battery, it is 11V. For 4 AA batteries with 1.5V, the default
low battery alarm voltage is 5V. When the transmitter voltage is lower than the alarm value, T8FB
will make D sound to warn.
To Next Page
Loading...
Need help?
General
