RADWAG AS series

- 84 -
TABLE 3
Variables dependent on a currently enabled working mode
Variable
Number of
characters
Description
Working mode in which the
variable is active
%W 16 or 18 * Mass of a single part PARTS COUNTING
%H 16 or 18 * HI high threshold
CHECKWEIGHING
%L 16 or 18 * LO Low threshold
%Z 16 or 18 * Target mass DOSING
%B 16 or 18 * Reference mass PERCENT SETUP
%A 14 Filter
ANIMAL WEIGHING
%b 14 Threshold (limit)
%i 14 Liquid
DENSITY DETERMINATION
%p 14 Procedure
%c 14 Temperature
%a 16 Liquid density
%v 16 Sinker volume
TABLE 4
Static variables available in all working modes except for weighing (basic mode)
Variable
Number of
characters
Description
%n
7
Measurement no.
%x
16
Average value
%S
16
Sum
%m
16
Minimum value
%M
16
Maximum value
%D
16
Difference between max and min value
%s
16
Standard deviation
%r
16
Variance factor
* depending on settings of a digit marker and printout parameter: to a printer / PC
** depending on the length of a name