RADWAG AS series User Manual

- 83 -
TABLE 2
Variables independent on an enabled working mode
Variable
Number of characters
needed for a variable
Variable description
%% 1 Printout of a single character “%”
%N 16 or 18 * Current net mass in basic measuring unit
%d 10 Current date
%t 8 (for 24-hour version) Current time
%i 8 Balance factory no.
%R 8 Software no.
%P 8 Project no.
%U 8 User no.
%F X ** Name of an active working mode
%C 25
Date and time of last completed adjustment
process
%K X ** Type of last completed adjustment process
%I 16 or 18 *
Deviation in last completed adjustment
process
%1 6 Code 1
%2 6 Code 2
%3 6 Code 3
%4 6 Code 4
%5 6 Code 5
%6 6 Code 6
%V 16 or 18 *
Mass in current measuring unit. Variable
value is combined with an active working
mode, e.g. number of counted parts in
Parts Counting mode or deviation from
reference mass in % in the Percent Setup
mode
* depending on settings of a digit marker and printout parameter: to a printer / PC
** depending on the length of a name

RADWAG AS series Specifications

General

Display	LCD with backlight
Maximum Capacity	Varies by model
Readability	Varies by model
Pan Size	Varies by model
Calibration	Internal or external, depending on model
Stabilization Time	≤ 3 seconds
Interface	RS232, USB
Repeatability (Standard deviation)	Varies by model
Linearity	Varies by model
Net Weight	Varies by model
Protection Class	IP 43