− On adding data on a non-standard printout set other printout parameters, such
as:
Printout no. – 1
Printout no. 1 start – 1
Printout no. 1 stop – 10
Fig. 68. Declaring printout content
− On setting printout parameters go back to the weighing mode with procedure of
saving carried out changes.
Next, connect a label printer to balance’s communication interface using a dedicated
cable (see figure on cross-section of a connecting cable given in this user manual).
Check transmission parameters of a balance and printer – they should be equal.
Place a weighed load on balance’s weighing pan and on stabilization of measurement
result press PRINT key on balance’s overlay. The balance sends data to a connected
printer complying with saved template, and the printer prints 3 labels as designed in
the software.
Presentation of a label:
Fig. 69. A presentation of a printed label
To Next Page
Loading...
