Radware Alteon - Page 10

Radware Alteon Installation and Maintenance Guide
10 Document ID: RDWR-ALOS-V2815_IG0203
Figure 4: Statement for Class B VCCI-certified Equipment
Translation of Statement for Class B VCCI-certified Equipment:
This is a Class B product based on the standard of the Voluntary Control Council for Interference by
Information Technology Equipment (VCCI). If this is used near a radio or television receiver in a
domestic environment, it may cause radio interference.
Install and use the equipment according to the instruction manual.
KCC KOREA
Figure 5: KCC—Korea Communications Commission Certificate of Broadcasting and
Communication Equipment
Figure 6: Statement For Class A KCC-certified Equipment in Korean
Translation of Statement For Class A KCC-certified Equipment in Korean:
This equipment is Industrial (Class A) electromagnetic wave suitability equipment and seller or user
should take notice of it, and this equipment is to be used in the places except for home.
SPECIAL NOTICE FOR NORTH AMERICAN USERS
For North American power connection, select a power supply cord that is UL Listed and CSA Certified
3 - conductor, [18 AWG], terminated in a molded on plug cap rated 125 V, [10 A], with a minimum
length of 1.5m [six feet] but no longer than 4.5m...For European connection, select a power supply
cord that is internationally harmonized and marked “<HAR>”, 3 - conductor, 0,75 mm2 minimum
mm2 wire, rated 300 V, with a PVC insulated jacket. The cord must have a molded on plug cap rated
250 V, 3 A.
RESTRICT AREA ACCESS
The DC powered equipment should only be installed in a Restricted Access Area.
INSTALLATION CODES
This device must be installed according to country national electrical codes. For North America,
equipment must be installed in accordance with the US National Electrical Code, Articles 110 - 16,
110 -17, and 110 -18 and the Canadian Electrical Code, Section 12.