Why is there no signal on my Radwin Microphone system?
If you are experiencing a 'No signal' issue with your Radwin Microphone system, make sure to complete the installation procedure using the RADWIN Manager. Also, verify the antenna alignment and ensure that the radio configuration (channel settings and Link ID) is the same for both site A and site B units.
What to do if the AIR I/F light is red on my Radwin Microphone system?
If the AIR I/F light is red on your Radwin Microphone system, check the antenna alignment. Also, verify that the radio configuration of both site A and site B units are the same (Channel and Link ID).
What to do if I have weak signal received on my Radwin Microphone system?
If you are getting a 'Weak signal received' on your Radwin Microphone system, you should check the antenna alignment and reconfigure the link. Also, check that the alignment tone sounds the Best Signal sequence.
What to do if the IDU light is red on my Radwin Microphone system?
If the IDU light is red on your Radwin Microphone system, check that the IDU/ODU cable is properly wired and connected.
What to do if the ODU light is red on my Radwin Microphone system?
If the ODU light is red on your Radwin Microphone system, check that the IDU/ODU cable is properly wired and connected.
How to fix PWR off on Radwin Microphone system?
If your Radwin Microphone system shows 'PWR Off', check that the power is connected to the IDU.
How to fix no power on Radwin Microphone system?
If your Radwin Microphone system has no power, ensure that power is connected to the IDU. Also, ensure that the ODU cable is properly wired and connected.
What does AIR I/F Orange mean on Radwin Microphone system?
If the AIR I/F light is orange on your Radwin Microphone system, complete the installation procedure from the RADWIN Manager.
What does SVC Orange Red Off mean on Radwin Microphone system?
If you see 'SVC Orange Red Off' on your Radwin Microphone system, it means an alarm was detected at the Site B interface, or a Local or Remote loopback Alarm was detected at the Site A interface Ethernet only IDU, or E1/T1 is not configured.
General| Product Type | Wireless Access Point |
|---|---|
| Max Throughput/Maximum Data Rate | 100 Mbps |
| Range | Up to 30 km |
| MIMO Technology | 2x2 MIMO |
| Ethernet Ports/Interface | 1 x 10/100/1000 Mbps Ethernet |
| Modulation | OFDM |
| IP Rating | IP67 |
| Frequency Band | 5 GHz |
| Power Supply | 48VDC |
| Security | AES 128 |
| Channel Bandwidth | 5 MHz, 10 MHz, 20 MHz |
To Next Page
