Radwin WinLink 1000 - Changing the Transmit Power; Defining the Management Addresses

WinLink 1000 Installation and Operation Manual Chapter 3 Configuration
Changing the Transmit Power
Each ODU can be configured to have a different transmit power level.
Î
To change the Transmit Power:
1. Click configuration from the main menu.
2. Select which site to configure.
The configuration dialog box opens.
3. Click the Air Interface Tab. (See
Figure 3-15 )
4. Select the required Transmit Power Level (See Figure
3-15, below).
Figure 3-15. Changing the Transmit Power
Defining the Management Addresses
Each site must be configured separately, first site A then site B.
Î
To define the Management Addresses:
1. Click configuration from the main menu.
2. Select which site to configure.
The configuration dialog box opens.
Performing Configuration of WinLink 1000 3-15