Chapter 2 Installation and Setup WinLink 1000 Installation and Operation Manual
2-4 Installation and Setup
Figure 2-1
illustrates a typical installation of WinLink 1000 with an
external antenna.
Figure 2-1. Typical Installation Diagram
Mounting the ODU
The ODU is the transmitting and receiving element of the WinLink 1000
system. The ODU can be mounted on a mast or a wall. In both
installations, the supplied mounting kit is used to secure the ODU.
Appendix B
describes the mast/wall installation instructions.
A WinLink 1000 link operates in pairs of two WinLink 1000 systems
with the same configuration. Both systems must be installed, and the
antennas of the outdoor units must be aligned for maximum
throughput.
To Next Page
Loading...
