WinLink 1000 Installation and Operation Manual Chapter 3 Configuration
This feature is for the 5.4GHz ETSI version product only.
DFS/TPC – Dynamic Frequency Select / Transmit Power control – ETSI
standard for the unlicensed band that eliminates interruption of the
wireless data equipment to the radar service.
The sign on the configuration Wizard and Status bar indicates that
the radar detection is on.
Figure 3-6. Link Configuration, Channel select dialog box with DFS
Automatic channel selection cannot be unchecked, due to ETSI
standard requirements.
A Channel reselection process interrupts the service for the period of
scanning and re-synchronization of the link. In most of the product
this process takes few seconds. In products that support DFS/TPC this
process might take few minute (each channel must be monitored for a
60 seconds before any transmission can start.
Performing Configuration of WinLink 1000 3-7
To Next Page
Loading...
