Radwin WinLink 1000 - Configuration, Management

Chapter 3 Configuration WinLink 1000 Installation and Operation Manual
3. Click the Management Tab (see Figure 3-16 ).
4. Enter the IP address of the ODU in the IP address field.
If performing configuration from the WinLink manager, the IP address
is entered in the login screen (
Figure 2-3)
Note
5. Enter the Subnet Mask.
6. Enter the Default Gateway.
7. Enter the Trap Destination. This is the IP address of the PC running
the management application. The event log will be stored at this
address.
Figure 3-16. Configuration, Management
3-16 Performing Configuration of WinLink 1000